OptiClimate CO2 Sensor for DimLux Maxi Controller. Separate OptiClimate CO2 sensor that can be connected to a DimLux Maxi Controller, and which also controls the CO2 generator or CO2 pressure reducing valve. Including Dual Beam sensor.
OptiClimate cable for remote control. This OptiClimate cable for the remote control of the OptiClimate water-cooled airco comes standard with all the models of the OptiClimate but is also available separately.
OptiClimate magnetic valve. The OptiClimate magnetic valve comes standard with all models of the OptiClimate watercooled airco and is also available separately.
OptiClimate Cooling block cleaner RTU foam spray. This OptiClimate Cooling block cleaner removes any bacteria and/or contamination that may build up on the cooling block of the OptiClimate.
Required if the OptiClimate is installed lower than the drain. Max 4 meters lifting. Suitable for a 7/4MM PVC hose. The lift pump is required if the OptiClimate is installed below the drain and the condensation water cannot flow way from the slope.
The OptiClimate PRO 3 and PRO 4 series water-cooled and air-cooled climate control systems have built-in dust and carbon filters. The OptiClimate carbon filter removes mould spores from the air and should be replaced every 10 to 12 weeks. One replace...
Three-way valve 250mm for 3500, 6000 PRO3 and PRO4
has been added to your shopping cart
OptiClimate three-way valve 250mm for 3500, 6000 PRO3 and PRO4. This three-way valve for the OptiClimate 3500, 6000 PRO3 and PRO4 should be used within the Dual Room setup: only one OptiClimate will be required to cool two rooms.
OptiClimate vibration isolator springs. These OptiClimate 3500 PRO 3 vibration isolator springs isolate vibrations by 98%. The silent OptiClimate can thus be made even more quiet. 4 pieces.
OptiClimate 3500 PRO3 Split EX air-cooled airco. The OptiClimate 3500 PRO3 Split EX aircooled airco has a cooling capacity of 3,5 kW. The OptiClimate 3500 PRO3 Split EX uses 820W and has 2x1500W heating elements. Extended Reach 30m.
OptiClimate Plenumbox 15000 PRO3 and PRO4. The plenum box is an insulated case that can be installed at the back of the OptiClimate 15000 PRO3 or PRO4. With a plenum box it is possible to place the OptiClimate outside the room or to use the Dual Room...
OptiClimate water pressure reducing valve with pressure gauge. High water pressure can create a rushing water sound in the water pipe of the OptiClimate. Should this occur, the water pressure reducing valve reduces this noise as well as the water ham...
OptiClimate heat exchanger cleaner. This OptiClimate heat exchanger cleaner cleans the heat exchanger of the OptiClimate. Suitable for all models of OptiClimate water-cooled airco.
The OptiClimate 15000 PRO3 water-cooled air conditioner has a cooling capacity of 15 kW, uses between 5 and 9 liters of water x minute and has 3x2700W heating elements.
The OptiClimate 10000 PRO3 water-cooled air conditioner has a cooling capacity of 10 kW, uses between 3 and 6 liters of water x minute and has 3x2000W heating elements.
OptiClimate aluminium tape. This OptiClimate aluminium tape is 100% vapour-proof and adheres particularly well even at higher temperatures. Extra wide for a better seal. Size: 50m x 10cm.
OptiClimate 10000 PRO3 Split EX air-cooled airco. The OptiClimate 10000 PRO 3 Split EX has a cooling capacity of 10kW. The OptiClimate 10000 PRO3 Split EX uses 2390W and has 3x2000W heating elements. Extended Reach 30m.
OptiClimate Plenumbox 10000 PRO3 and PRO4. The plenum box is an insulated case that can be installed at the back of the OptiClimate 10000 PRO3 and PRO4. With a plenum box it is possible to place the OptiClimate outside the room or to use the Dual Roo...
OptiClimate CO2 pressure reducing valve for gas cylinders with high-quality magnetic valve. Provided with fine adjustment for accurately controlling the climate of any room.